| Customization: | Available |
|---|---|
| CAS No.: | 63148-60-7 |
| Formula: | Ho-Si(CH3)2o[Si(CH3)2o]Nsi(CH3)2-Oh |
|
Still deciding? Get samples of US$ 0.1/Piece
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Other product | Other product | ||
| Property | Unit | Result | Result |
| appearance | clear,white | clear | |
| Uncured specific gravity | pas | 1.08,1.56 | 1.08 |
| Viscosity at 120°C (248°F) | wt% | >60 | >60 |
| Nonvolatile content | minutes | ≥97.5 | ≥98.5 |
| Open time2 | days | 20 | 15 |
| Cure time, 3 mm bead³ | <2 | <2 | |
| Hardness - durometer Shore A | psi | 55-65 | 55-65 |
| Ultimate tensile strength | >600 | >600 | |
| Ultimate elongation | % | >1200 | >1200 |
| Adhesion-in-peel strength | pli | >30 | >30 |
| Service temperature range | ºC(ºF) | -50 to 150 (-58 to 302) | -50 to 150 (-58 to 302) |
| Shear adhesion failure temperature | ºC(ºF) | > 300 (> 572) |
> 300 (> 572) |
Product Feature
1. Single component, easy to use, good extrudability and thixotropy in the temperature range of 4°C ~ 40°C, can be applied
directly by using a glue gun;
2. After curing, it will not become brittle, harden or crack at low temperatures of -30°C. It will not soften or degrade at high
temperatures, but will shrink to a certain extent and increase in hardness;
3. Excellent weathering resistance, aging, UV, ozone and water resistance;
4. Excellent resistance to high and low temperatures, will not become brittle, hardened or cracked at -30°C after curing, and will
not become soft and degraded at high temperatures, but there is a certain shrinkage, and the hardness has increased;
5. Good adhesion, forming a strong seal with most building materials when cured without the need for a primer;
6. Good compatibility with other neutral silicone adhesive
1.Before construction, the glass-roots level will be cleaned up, no dust, oil and other substances that affect the bonding strength.
2.This product can be used for spot gluing, the spot gluing area should be not less than 10% of the pasted area; you can also use the following 4mm tooth-shaped trowel to pull the teeth of the full scraping and paving, after the completion of the adhesive layer thickness of up to 3mm is good.
3.Adjustment should be completed within ten minutes after dispensing.
4.The product room temperature curing, surface drying time: 45Min, full curing time: 24h.
5.Application temperature range: -40ºC-+100ºC..
1.Prohibit contact with water, steam, alcohol solvents (such as alcohol).
){kind=link}